26.Running in on the target 27.Depress the gun pods to the desired angle by watching the gun reticle on the HUD. 28.Maneuver the aircraft to place the reticle over the target. 29.Fire! 30.Well attack the next target with only two pods. To do so, set the Ripple Quantity switch to По 2 (Po 2) by pressing LCTRL + Space. 31.For this run, well switch to Programmed Point Tracking mode, which is enabled automatically when the laser is active and guns pods are selected. In this mode, the guns will automatically stay fixed to the aimed point. If we fly the aircraft carefully without inducing any roll, the entire burst will land in one spot. 32.Lets disable automatic burst cut-off by pressing LShift + C. The guns will now fire as long as the trigger is held down. 33.Running in on the target. 34.Activate the laser and thus enabling the Programmed Point Tracking mode. 35.Maneuver to place the reticle over the target 36.Press the trigger to fire and hold it down until the attack is complete. 37.After a minute of activation, the laser turns off automatically to cool down. 38.Well attack the next target with all four SPPU pods. To do so, set the Ripple Quantity switch to По-4. 39.The lower part of the WCS Panel contains three windows that display the amount of ammunition remaining as follows: -outer external gun pods -inner external gun pods -internal gun Note that the ammunition remaining is displayed in quarters: K fully loaded 3/4 75% remaining 1/2 50% remaining H3 (Russian NZ ...
Related : ±1±: Hot Cell Phones & Service Store +99% Buying Plasma HDTV +99% low-price-tents-shelters-20 !!1 Casio Exilim 10.1 Discount
0 comments:
Post a Comment